Installation Instructions

Fiber Optic Removal and Installation

To Remove: Utilizing a top through hole as a guide, twist supplied drill bit with fingers until fiber optic has been cut in half

To Install: Trim fiber optic rod within 1/32nd” of each end of sight, ensuring the cut is straight and square then carefully melt the fiber optic ensuring each end is melted flush to sight

Front Sight Installation

  • After removing front sight bolt, carefully slide front sight boss into slide sight hole ‐ Tap front sight flush to top of slide utilizing a soft tipped mallet
  • Apply temporary thread locking compound to front sight bolt
  • Rotate front sight bolt until head of bolt contacts slide
  • Torque 25‐30° past this point

Rear Sight Installation

  • Prior to rear sight installation, ensure set screw is not protruding from bottom of sight ‐ Visually center rear sight to center line of slide
  • Fine tune center line of rear sight window to center line of front sight to within .001″
  • Rotate set screw until head of screw contracts slide
  • Torque 20° past this point

Tools and Materials Needed

For Fiber Optics: Nail clippers and cigarette lighter
For Sight installation: 3/16″ thin walled hex head screw driver (Glock front sight installation tool), soft tipped mallet, thread locking compound, rear sight press or soft tipped punch, 1.5 mm hex wrench

Active military, veterans, law enforcement and first responders receive a 10% discount

Email [email protected] for information.

Wahrheit Glock Sights